Sick Srt-4
11-04-2005, 04:56 PM
On the 03's and 04's (haven't confirmed 05's yet)
The wire colors are as follows:
Constant Power = Red w/ Blue stripe
Accessory Power = Red w/ White stripe
Ground = Thick black
Remote (ant) = (not available)
Dimmer = Solid orange - NO stripe
Left Front + = Solid Green
Left Front - = Brown w/ Red Stripe
Right Front + = Solid Purple
Right Front - = Blue w/ Red Stripe
Left Rear + = Blue w/ White Stripe
Left Rear - = Blue w/ Orange Stripe
Right Rear + = Brown w/ Yellow Stripe
Right Rear - = Brown w/ Blue Stripe
There is Purple w/ Yellow Stripe IF you do not have the factory navigation system it is un-used. It's a BUS wire for the factory navigation.
Keep in mind, there are 4 front speakers in our cars. To find the wires for the tweeters, if you remove the kick panel, and go after the harness going into the doors you will find the connector for the door. The "signal" wires going into the door are tap'd in the connector to send the signal up to the tweeters.
I'd suggest if running an amp, to correct this. The wires need to be either disconnected and not used and seperate wire ran, or modified.
REMEMBER to confirm all wire colors, and their function. I am not resposible if you fry something by using my info without verifying for yourself. (Seriously, I'm sure of my wire ID's but check for your safety)
The wire colors are as follows:
Constant Power = Red w/ Blue stripe
Accessory Power = Red w/ White stripe
Ground = Thick black
Remote (ant) = (not available)
Dimmer = Solid orange - NO stripe
Left Front + = Solid Green
Left Front - = Brown w/ Red Stripe
Right Front + = Solid Purple
Right Front - = Blue w/ Red Stripe
Left Rear + = Blue w/ White Stripe
Left Rear - = Blue w/ Orange Stripe
Right Rear + = Brown w/ Yellow Stripe
Right Rear - = Brown w/ Blue Stripe
There is Purple w/ Yellow Stripe IF you do not have the factory navigation system it is un-used. It's a BUS wire for the factory navigation.
Keep in mind, there are 4 front speakers in our cars. To find the wires for the tweeters, if you remove the kick panel, and go after the harness going into the doors you will find the connector for the door. The "signal" wires going into the door are tap'd in the connector to send the signal up to the tweeters.
I'd suggest if running an amp, to correct this. The wires need to be either disconnected and not used and seperate wire ran, or modified.
REMEMBER to confirm all wire colors, and their function. I am not resposible if you fry something by using my info without verifying for yourself. (Seriously, I'm sure of my wire ID's but check for your safety)