Log in

View Full Version : my motor go BOOM!


DJ2
07-20-2018, 01:11 AM
yeah, compression test confirms 150, 147, 153, 70 :owned:

so I will be tearing down the motor over the next few days to check out the damage.... my money is on the ring lands.

If the cylinders are in good shape I will probably buy a set of pistons and rings and call it a day.... if not I have some figuring to do.

I can get a rebuilt with 1200 miles on it:
stock block
JE 8.0:1 pistons and rings
Eagle rods
DCR oil pump and pickup tube
no balance shafts
DCR windage tray
DCR crank scraper
new water pump
ARP head studs
Head with tri-angle valve job, new valve seals, valves and springs.
for $2000 or best offer from a local.

OR

I can buy a new short block from Jimmy for $900 + shipping and call it a day.


either way I hate life!

el_jefe
07-20-2018, 09:28 AM
Damn, WTF. You have been babying that fucker with the new clutch too.

DJ2
07-20-2018, 09:53 AM
Damn, WTF. You have been babying that fucker with the new clutch too.
yeah, but I was running it @ 30psi when I realized I needed a better clutch.

el_jefe
07-20-2018, 09:58 AM
oops.

DJ2
07-20-2018, 10:02 AM
yeah, I am pretty sure a ring land finally let go. Shitty thing is whenever I have run high boost, I have had 100% meth in the tank, Torco Accellerator in the fuel, 0 KR and 19-23* advance @ WOT

91 gt
07-20-2018, 10:24 AM
three letters... F.D.S!!!!! :lulz: :lulz:

mole'
07-20-2018, 10:25 AM
yeah, but I was running it @ 30psi when I realized I needed a better clutch.
30PSI

DJ2
07-20-2018, 10:55 AM
30PSI
3076R

mole'
07-20-2018, 10:56 AM
3076R
S3 will take it down..........:nawz:

DJ2
07-20-2018, 10:57 AM
S3 will take it down..........:nawz:
:rosie:

mole'
07-20-2018, 11:02 AM
:rosie:
lol........:furious3:

DJ2
07-20-2018, 11:05 AM
lol........:furious3:
:henry:

mole'
07-20-2018, 11:10 AM
:henry:
:daryl: :jeff: :stfu:

el_jefe
07-20-2018, 11:11 AM
S3 will take it down..........:nawz:


According to ptperformance, the SST is almost=S3 modded :ftard:

mole'
07-20-2018, 11:13 AM
According to ptperformance, the SST is almost=S3 modded :ftard:
what?

AJ Quick
07-20-2018, 11:33 AM
30PSI

3076R

206842 Pascals

DJ2
07-20-2018, 12:16 PM
According to ptperformance, the SST is almost=S3 modded :ftard:
GT37>GT35>GT3076>50TRIMDBB>60TRIM>50TRIM>20G>S3>SST,E1,SHOCKER>STOCKER
these are my opinions so anyone that wishes to argue...


go suck a fat cock!

DJ2
07-20-2018, 12:17 PM
206842 Pascals
1.21 gigawatts

el_jefe
07-20-2018, 12:21 PM
GT37>GT35>GT3076>50TRIMDBB>60TRIM>50TRIM>20G>S3>SST,E1,SHOCKER>STOCKER
these are my opinions so anyone that wishes to argue...


go suck a fat cock!


Good tune > anything with a crap tune

DJ2
07-20-2018, 12:35 PM
Good tune > anything with a crap tune
stock > my car right now... :fail:

91 gt
07-20-2018, 12:46 PM
stock > my car right now... :fail:

ha ha... i win!!

91 gt
07-20-2018, 12:47 PM
jefe - how does next weekend look for you?

blackbird
07-20-2018, 12:48 PM
If it was really at 30 psi when it went I hope you were on C16 and not using a piggyback. Even around 20 degree advance is way too much for that boost level and any small hiccup will kill something.

blackbird
07-20-2018, 12:50 PM
As for suggestions if you're going to really push the limits of that turbo a set of good forged pistons would be nice insurance but won't take place of the correct timing and fueling.

DJ2
07-20-2018, 01:28 PM
If it was really at 30 psi when it went I hope you were on C16 and not using a piggyback. Even around 20 degree advance is way too much for that boost level and any small hiccup will kill something.
pressure was only @ 20psi when it went... I only turn up the boost when I have tuned for weather conditions, running 105 octane or higer and have 100% meth in the injection. I am assuming that my temps were really high because there was signs of melting on the plugs when I pulled them and the ceramic was broken on one (I initially thought that was the problem)

el_jefe
07-20-2018, 01:46 PM
jefe - how does next weekend look for you?

as in tomorrow, or the 27th?

91 gt
07-20-2018, 01:56 PM
as in tomorrow, or the 27th?

27th

el_jefe
07-20-2018, 01:58 PM
As far as I know, nothing is going on. Should be fine

91 gt
07-20-2018, 02:14 PM
As far as I know, nothing is going on. Should be fine

koo :giggity:

thepowertowin
07-20-2018, 02:42 PM
DJ.. let me get you a shipped price for a stock short block...

Email or pm me your shipping information (full address) and if you can get it shipped to a commercial address it's MUCH cheaper.

2clean2drive
07-20-2018, 09:32 PM
get the new short block from jimmy and go back to stock with bolt ons, the car will last 100times longer....also i saw your thread on sotsyn and i appreciate you not trashing my friends memorial thread unlike that fag alex...

slow4dr
07-20-2018, 11:01 PM
GT37>GT35>GT3076>50TRIMDBB>60TRIM>50TRIM>20G>S3>SST,E1,SHOCKER>STOCKER
these are my opinions so anyone that wishes to argue...


go suck a fat cock!


:bblz:

DJ2
07-30-2018, 01:19 PM
all 4 cylinder ring lands had cracks, Cyl # 1 lost a piece below the oil ring. Cyl walls look good so I will hone them and call it a day. Ordering parts today if Jimmy gets back to me on nazi forums with pricing.

punkrokdood
07-30-2018, 01:22 PM
DCR windage tray :repuke: DCR crank scraper

DJ2
07-30-2018, 01:31 PM
DCR windage tray :repuke: DCR crank scraper
I would like to, but this is an unexpected rebuild (hoped it would make it till tax time) and funds are tight.... cutting BS chain is going to have to do for now.

punkrokdood
07-30-2018, 01:33 PM
I would like to, but this is an unexpected rebuild (hoped it would make it till tax time) and funds are tight.... cutting BS chain is going to have to do for now.
my point is don't buy the DCR/ACE hardware joint venture POS

DJ2
07-30-2018, 02:11 PM
my point is don't buy the DCR/ACE hardware joint venture POS
roger....

you sell that oil kit yet?

punkrokdood
07-30-2018, 02:23 PM
roger....

you sell that oil kit yet?
nope... still got it

mole'
07-30-2018, 02:45 PM
DJ.. let me get you a shipped price for a stock short block...

Email or pm me your shipping information (full address) and if you can get it shipped to a commercial address it's MUCH cheaper.
x2..........

DodgeZ
07-31-2018, 03:29 PM
you wnat to sell the blown motor?

|